TEC SX4T - B B/W Direct Thermal User Manual page 179

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
6) Secure the PCMCIA interface board to the PCB support plate with the SM-3x6 screw.
Tighten the two M-3x5 screws that were loosened previously. (Refer to Caution)
7) Attach the blind plate A to the rear plate with the two SM-3x6 screws that were removed in step 6).
If the LAN interface board or USB interface board is also installed, go to the next step.
NOTE: Keep the two SM-3x6 screws and blind plate A safe when the LAN interface board or USB
interface board is installed.
Rear Plate
SM-3x6 Screw
8) Reassemble the side panel (L) in the reverse order of removal. If the Expansion I/O board was
removed at the beginning, reassemble it.
NOTE: For inserting, removing, and handling the PC card, refer to the Owner's Manual.
M-3x5 Screw
4.5 PCMCIA INTERFACE BOARD (B-9700-PCM-QM)
SM-3x6 screw
4-22
EO18-33012A
PCB Support Plate
Blind Plate A