TEC SX4T - B B/W Direct Thermal User Manual page 255

6. ON LINE MODE
n LCD message and LED indication
Symbols in the message
1: m: The LED is illuminated. ¤: The LED is flashing. l: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: %%%%%%%: ATA Card's remaining memory 0 to 9999999 (in K bytes)
4: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
5: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
No. LCD Message
ON LINE
1
ON LINE
2 HEAD OPEN
3 PAUSE
****
4 COMMS ERROR
5 PAPER JAM ****
6 CUTTER ERROR****
7 NO PAPER
****
8 NO RIBBON ****
9 HEAD OPEN ****
10 HEAD ERROR
11 EXCESS HEAD TEMP
12 RIBBON ERROR****
13 REWIND FULL ****
SAVING%%%%%%%
14 or
SAVING ###&&&&
15 FLASH WRITE ERR.
16 FORMAT ERROR
17 FLASH CARD FULL
Display of error
18
message (See Notes.)
19 POWER FAILURE
20 INTIALIZING...
100BASE LAN
21
INITIALIZING...
DHCP CLIENT
22
INITIALIZING...
LED Indication
POWER ONLINE ERROR
m m l
In online mode
In online mode (The printer in
m ¤ l
communication)
The print head block is opened in online
m l l
mode.
m l l
The printer is paused.
A parity, overrun, or framing error has
m l m
occurred during communication through
the RS-232C.
m l m
The media is jammed during paper feed.
A problem has occurred with the cutter
m l m
module.
The media has run out, or the media is
m l m
not loaded properly.
m l m
The ribbon has run out.
Feed or printing was attempted with the
m l m
print head block open.
m l m
There is a problem with the print head.
m l m
The print head is overheated.
The ribbon has been torn. A problem has
m l m
occurred with the sensor that determines
the torque for the ribbon motor.
An overflow error has occurred in the
m l m
rewinder unit.
In writable character or PC command
m m l
save mode
An error has occurred while writing to
m l m
flash memory or ATA card.
An erase error has occurred in formatting
m l m
the flash memory or ATA card.
Data cannot be stored because the flash
m l m
memory or ATA card is full.
A command error has occurred in
m l m
analyzing the command.
m l m
A power failure has occurred.
m l l
A flash memory card is being initialized.
100BASE LAN is now being initialized.
m l l
(Only when the optional B-9700-LAN-QM
is installed.)
DHCP CLIENT is now being initialized.
m l l
(Only when the DHCP is effective.)
Printer Status
6- 3
EO18-33012A
6. ON LINE MODE
Acceptance
of Status
Restoration by
Request
RESTART key
Reset
Yes/No
Command
Yes/No
----- Yes
----- Yes
----- Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
----- Yes
No Yes
No Yes
No Yes
Yes Yes
No No
----- -----
----- -----
----- -----