Locations; Removing The Cover And Bezel - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

v Always handle components carefully. Handle adapters, the memory board, and
v Prevent others from touching components.
v When you are installing a new option, touch the static-protective package
v When possible, remove the option and install it directly into the server without
v Do not place the option on the server's covers or any metal surface.

Locations

The following sections describe how to remove and/or install certain components
inside the server.

Removing the cover and bezel

The following section describes how to remove the cover and bezel.
To remove the server top cover:
1. Review the information in "Before you begin" on page 40.
2. If you are planning to install or remove any part other than a hot-swap hard disk
42
Hardware Maintenance Manual: xSeries 342 Type 8669
memory modules (DIMMs) by the edges. Never touch any exposed circuitry.
containing the option to a metal expansion-slot screw or other unpainted metal
surface on the server for at least two seconds. (This reduces static electricity
from the package and from your body.)
setting the option down. When this is not possible, place the static-protective
package that the option comes in on a smooth, level surface and place the
option on it.
Side latch
drive, hot-swap power supply, or hot-swap fan, turn off the server and all
attached devices and disconnect all external cables and power cords.
Statement 1:
Cover-release latch
Side latch
Bezel