F32Fi Module - Extreme Networks Alpine 3808 Hardware Manual

BlackDiamond 6800 Series I/O Modules

F32Fi Module

Figure 130 shows the F32Fi module.
Figure 130: F32Fi module
Module status LEDs
1 9 17 25
2 10 18 26
3 11 19
27
Port status LEDs
4 12 20 28
5 13 21 29
6
14 22 30
7 15 23 31
8 16 24 32
1 17
4 20
5 21
100 Mbps
8 24
9 25
ports
12 28
13 29
16 32
BD_F32Fi
All F32Fi ports have 32 100BASE-FX ports and use standard MT-RJ connectors.
The default configuration of the F32Fi modules is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in 100 Mbps, full-duplex mode. Half-duplex mode is not supported.
LEDs
The F32Fi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the F32Fi module, see "I/O Module LEDs" on
page 277.
Software Requirements
The F32Fi module requires that you load ExtremeWare version 6.1.8 or later and BootROM 6.5 or later
on the switch.
262 Extreme Networks Consolidated Hardware Guide