Installing The Alpine 3808 Or Alpine 3804 Fan Tray - Extreme Networks Summit Summit1i Hardware Installation Manual

Alpine 3800 Series Switch Fan Tray
Figure 87: Alpine 3804 fan tray
Finger grips
4 Allow the fan blades to stop spinning before you remove the fan tray from its slot.
WARNING!
Keep your hands away from rotating fan blades.
5 To support the fan tray, place one hand under the fan tray and use the other hand to pull the fan
tray from its slot.
6 Leave the ESD strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.

Installing the Alpine 3808 or Alpine 3804 Fan Tray

Alpine 3808 and Alpine 3804 fan trays are hot-swappable. You do not need to turn off power to an
Alpine 3808 or Alpine 3804 switch to install a fan tray.
You need the following tools and equipment to install a fan tray:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• Replacement fan tray
CAUTION
Only trained service personnel should perform service to Alpine 3808 or Alpine 3804 fan trays. Before
installing or removing any components, or carrying out any maintenance procedures, see Appendix A.
To install the fan tray in the Alpine 3808 or Alpine 3804 switch:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-right corner of the switch front panel.
2 Check the connectors for dust and packing materials.
184
38_fanx4
Extreme Networks Consolidated "i" Series Hardware Installation Guide