Automatic Return To Normal Display - Omron K3HB-C User Manual

5.28 Automatic Return to Normal Display

2
ret
L
(RET)
0
L
Displays "L 0."
sv. dsp
2
L
off
Displays "L 2."
ret
2
L
10
ret
2
L
10
ret
2
L
03
pos-t
2
L
inc
123. 4
123. 4
If no keys operations are performed for a specified time in the RUN
level or adjustment level, the display will automatically return to the
display status activated when the power was turned ON. The time until
the display returns automatically can be set and the automatic display
return can be disabled through this setting.
Automatic display return settings are made using the following
parameter.
Parameter
Automatic display return
ret
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least 3 s in RUN level to move to
L
the initial setting level.
3 s min.
0" is displayed on the level/bank display to indicate the initial
• "
L
setting level.
B Press the L [LEVEL] Key several times to move to the display
L
adjustment level.
2" is displayed on the level/bank display to indicate the
• "
L
display adjustment level.
C Press the M [MODE] Key several times to change the PV display
M
to "ret."
D Press the S [SHIFT] Key to make the SV display flash.
S
• The setting can be changed when the SV display starts to
flash.
E Use the U [UP] and S [SHIFT] Keys to change the set value.
U
F Press the M [MODE] Key to switch to the next parameter.
M
• The set value is registered.
G Press the L [LEVEL] Key for at least 1 s to return to RUN level.
L
1 s min.
5.28 Automatic Return to Normal Display
Display adjustment level
Set value Meaning of set value
0 to 99
0 to 99 s
Automatic display return will
not occur if set to 0.
R P C
5-73