Omron K3HB-C User Manual page 91

Section 5 Functions and Operations
Decimal Point Position
dp
0
L
,,. ,,,
dp
0
L
,,. ,,,
dp
0
L
,,,.,,
out-p
0
L
nomal
1234. 5
1234. 5
Teaching
ps.ax
0
2
T lights.
ps.ax
0
00002
ps.ax
0
00004
ps.ax
0
2.0000
T changes from
flashing to lit.
Remarks
5-30
H Press the M [MODE] Key to switch the PV display to the next
M
parameter "dp."
I Press the S [SHIFT] Key to make the SV display flash.
S
• The setting can be changed when the SV starts to flash.
J Use the U [UP] Key to change the set value.
U
K Press the M [MODE] Key to switch to the next parameter.
M
• The set value is registered.
L Press the L [LEVEL] Key for at least 1 s to return to the RUN
L
level.
1 s min.
Use the teaching function to set the scaling input value "ps. ax" using
a real input.
* The K3HB-P does not support teaching.
Parameter Setting Procedure
After performing step B, press the U [UP] Key.
U
• Teaching is enabled and "T" flashes.
• The setting changes to match the actual input.
Press the U [UP] Key again.
U
• The entered value is set and the SV starts flashing.
Use the U [UP] and S [SHIFT] Keys to change the set value.
U
• Change the set value to the desired value.
Press the M [MODE] Key to set the displayed value.
M
• The prescale value calculated based on the input value and the
display value is registered, and the display switch to monitor
mode.
• In teaching status, pressing the M [MODE] Key cancels
teaching and switches to the next parameter.
"5.30 Using Prescale/Comparative Set Value Banks" P.5-75