Omron K3HB-C User Manual page 66

Knowledge Required for Setting Parameters
Procedure
The Setting Level Protect setting must be set to 0 (set.pt=0) to
enable moving to the advanced function setting level.
Refer to "5.34 Limiting Key Operations" (P.5-84) for the procedure to
release protection.
A Move to the initial setting level, press the M [MODE] Key several
times to display the "amov" (move to advanced function setting
level) parameter.
B Press the S [SHIFT] Key to enable entering the password.
C Use the S [SHIFT] and U [UP] Keys to set the password.
The password is "-0169" (-0169).
D Press the M [MODE] Key to write the password.
• The advanced function setting level will be entered if the password
is correct.
• If the password is incorrect, the first parameter on the initial setting
level will be displayed.
The set value is always 0 after moving
from character display to monitor status.
Move to the advanced function setting level.
amoV
0
To next parameter
(Does not move to the advanced function setting level.)
Advanced function setting level
Change status
amoV
0
0
Use the S [SHIFT]
and U [UP] Keys
to set the password.
Password doesn't match.
Password matches.
Set value initialization
init
f
00169
off
5-5