Expansion Mode; Option Mode - Omron E5AK Datasheet

Expansion Mode

Set point
Upper Limit
Set point
Lower Limit
PID/ON/OFF
Unavailable to the
E5@K-PRR2.
ST
Available if the Controller in standard control and
advanced PID control has a temperature input.
Unavailable to the E5@K-PRR2
ST Stable Range
Available if the Controller in standard control and advanced
PID control with the ST set to OFF has a temperature input.
Unavailable to the E5@K-PRR2
Available if the Controller is in advanced
PID control with the ST set to OFF.
AT Calculated Gain
Available if the Controller is in advanced
PID control with the ST set to OFF.
Standby Sequence
Reset Method
Automatic Return
of Display Mode
AT Hysteresis
Available if the Controller is in advanced
PID control with the ST set to OFF.
LBA Detection
WidthAvailable only when the LBA (loop break
alarm) function is assigned.
Unavailable to the E5@K-PRR2.
28
Digital Controller
E5AK/E5EK

Option Mode

Multi-SP Function
Available for the event input functions.
Event Input Assignment 1
Available for the event input function.
Event Input Assignment 2
Available for the event input function.
Event Input Assignment 3
Available for the event input function.
Event Input Assignment 4
Available for the event input function.
Communication Stop Bit
Used when the communications function is being used.
Communication Data Length
Used when the communications function is being used.
Communication Parity
Set when the communications function is being used.
Communication Baud Rate
Set when the communications function is being used.
Communication Unit No.
Set when the communications function is being used.
Transfer Output Type
Set when the transfer output function is being used.
Transfer Output Upper Limit
Set when the transfer output function is being used.
Transfer Output Lower Limit
Set when the transfer output function is being used.
HBA latch
Remote SP enable
Remote SP Upper
Limit
(Available when the
remote SP is enable.)
Remote SP Lower Limit
(Available when the remote SP is enable.)
SP tracking
(Available when the remote SP is enable.)
For E5@K-PRR2
Motor
calibration
Travel time
PV dead
band