7.5.8
Replacing the 10x 2.5-inch HDD backplane
Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
Removing the defective 10x 2.5-inch HDD backplane
Figure 95: Disconnecting the power cable
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
46.
Upgrade and Maintenance Manual
Hardware: 10 minutes
43.
47.
49.
142.
45.
139.
159