Replacing The 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

Removing the defective 3.5-inch HDD module
▶ Remove the HDD module, see
page 144.
▶ If applicable, remove the HDD from the installation frame, see
HDDs or SSDs without installation frame" on page
Installing the new 3.5-inch HDD module
▶ If applicable, install the HDD in the installation frame, see
or SSDs without installation frame" on page
▶ Install the HDD module, see
page 142.
Concluding steps
▶ If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see
rebuild" on page
7.4.5

Replacing the 3.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: tool-less
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Removing a 3.5-inch HDD module" on
"Installing a 3.5-inch HDD module" on
87.
Upgrade and Maintenance Manual
135.
135.
"Performing a RAID array
Hardware: 10 minutes
43.
45.
46.
48.
"Handling
"Handling HDDs
147