Requirements For Abb Motors, P - ABB ACS580 Series Hardware Manual

Requirements for ABB motors, P

See also Abbreviations (page
Motor type Nominal AC line
Random-wound
M2_, M3_ and
M4_
Form-wound HX_
and AM_
1)
Old form-
wound HX_ and
modular
0 V < U n ≤ 500 V
Random-wound
2)
HX_ and AM_
HDP Consult the motor manufacturer.
1) manufactured before 1.1.1998
2) For motors manufactured before 1.1.1998, check for additional instructions with the motor manufacturer.
Guidelines for planning the electrical installation 99
> 100 kW (134 hp)
n
102).
voltage
Motor insu-
lation sys-
U n ≤ 500 V Standard
500 V < U n ≤
Standard
600 V
Reinforced
600 V < U n ≤ Reinforced
690 V (cable
length ≤ 150 m)
600 V < U n ≤
Reinforced
690 V (cable
length > 150 m)
380 V < U n ≤ Standard
690 V
380 V < U n ≤ Check with
690 V the motor
manufac-
Enamelled
wire with
500 V < U n ≤
fiber glass
690 V
Requirement for
ABB d u /d t and common mode filters, in-
sulated N-end motor bearings
tem
100 kW ≤ P n < 350
kW
or
IEC 315 ≤ frame size
< IEC 400
134 hp ≤ P n <
469 hp
or
NEMA 500 ≤ frame
size ≤ NEMA 580
+ N
+ N + d u /d t
+ N
+ N + d u /d t
+ N
+ N + CMF
+ N + d u /d t with voltages over 500 V +
turer.
taping
P n ≥ 350 kW
or
frame size ≥
IEC 400
P n ≥ 469 hp
or
frame size >
NEMA 580
+ N + CMF
+ N + d u /d t + CMF
+ N + CMF
+ N + d u /d t + CMF
+ N + CMF
P n < 500 kW: +N +
CMF
P n ≥ 500 kW: +N +
d u /d t + CMF
CMF
+ N + CMF
+ N + d u /d t + CMF