262 Maintenance
LEDs
■
Drive LEDs
There is a green POWER and a red FAULT LED on the front of the drive. They are
visible through the panel cover but invisible if a control panel is attached to the
drive. The table below describes the drive LED indications.
Drive LEDs POWER and FAULT, on the front of the drive, under the control panel / panel
cover
If a control panel is attached to the drive, switch to remote control (otherwise a fault
will be generated), and then remove the panel to be able to see the LEDs
LEDs
LED lit and steady
off
No
Green
Power supply on the board OK
power
(POWER)
Red
Active fault in the drive. To re-
(FAULT)
set the fault, press RESET from
the control panel or switch off
the drive power.
LED blinking
Green
Blinking:
Drive in an alarm state
(POWER)
Blinking for one second:
Drive selected on the control
panel when multiple drives are
connected to the same panel
bus.
Red
Active fault in the drive. To re-
(FAULT)
set the fault, switch off the
drive power.