154 Electrical installation – Global (IEC)
R6...R9
3
3a
Motor cable
6. Cut an adequate hole into the rubber grommet. Slide the grommet onto the
cable.
7. Prepare the ends of the input power cable and motor cable as illustrated in
the figure. If you use aluminum cables, put grease to the peeled aluminum
cable before connecting it to the drive. Two different motor cable types are
shown in the figures (7a, 7b).
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made
from the shield as a PE conductor with yellow-and-green color.
R6...R9
4
3b
3a
R8...R9
5