456 Optional I/O extension and adapter modules
■
Mechanical installation
Necessary tools
•
Screwdriver and a set of suitable bits.
Unpacking and examining the delivery
1.
Open the option package. Make sure that the package contains:
•
the option module
•
a mounting screw.
2. Make sure that there are no signs of damage.
Installing the module
See section
Installing option modules (page
■
Electrical installation
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section
before you start the work.
Necessary tools
•
Screwdriver and a set of suitable bits
Wiring
Connect the external control cables to the applicable module terminals. Ground
the outer shield of the control cables 360° under the grounding clamp on the
grounding shelf
WARNING!
Do not connect the +24 V AC cable to the control unit ground when the control
unit is powered using an external 24 V AC supply.
■
Start-up
Setting the parameters
1.
Power up the drive.
2. If no warning is shown,
•
make sure that the values of both parameters 15.01 Extension module type
and 15.02 Detected extension module are CMOD-02.
164).
Electrical safety precautions (page 24)