Ip55 (Ul Type 12); Installing The Drive Vertically Side By Side; Installing The Drive Horizontally, Frames R1; Flange Mounting - ABB ACS580 Series Hardware Manual

IP55 (UL Type 12)

9. Remove the front cover: Remove the fastening screws (a) with a T20 Torx
screwdriver, move the cover to the top side (b) and then up (c).
6b
6a
Note: Install the hood to UL Type 12 drives after you have installed the drive
electrically and reinstalled covers, see
￭

Installing the drive vertically side by side

Install the drive following the steps in the appropriate section
vertically, frames R1...R4 (page
or Installing the drive vertically, frames R6...R9 (page
￭ Installing the drive horizontally, frames R1...R5
Install the drive following the steps in the appropriate section
vertically, frames R1...R4 (page 86)
R5 (page 88). The drive can be installed either the left or right side up.

Flange mounting

Instructions for flange mounting are delivered with the flange mounting kit:
Flange mounting kit quick installation guide for ACX580-01 frames R1 to R3
(3AXD50000119172 [English])
Flange mounting kit quick installation guide for ACX580-01 frames R4 to R5
(3AXD50000287093 [English])
Flange mounting kit quick installation guide for ACS880-01 and ACX580-01 frames R6 to
R9 (3AXD50000019099 [English])
Flange mounting quick installation guide for ACX580-01 IP66 (Type 4X) frames R1 to R3
(3AXD50001019310) [English]
6c
6a
Installing UL Type 12 hood (page
86), Installing the drive vertically, frame R5 (page 88)
or Installing the drive vertically, frame
Mechanical installation 93
212).
Installing the drive
91).
Installing the drive