Ce Marking; Compliance With The European Low Voltage Directive; Compliance With The European Emc Directive; Compliance With The European Rohs Ii Directive 2011/65/Eu - ABB ACS580 Series Hardware Manual

356 Technical data
Note: The ACS580-01 230 V 3-phase R9 drives have NOT been verified to comply
with CSA, CE or IEC directives or any other world standards outside of North
America.

CE marking

A CE mark is attached to the drive to verify that the drive follows the provisions
of the European Low Voltage, EMC and RoHS Directives.The CE marking also verifies
that the drive, in regard to its safety functions (such as Safe torque off), conforms
with the Machinery Directive as a safety component.
￭

Compliance with the European Low Voltage Directive

The compliance with the European Low Voltage Directive has been verified
according to standard EN 61800-5-1:2007. The declaration of conformity
(3AXD10000302784) is available on the Internet. See section Document library on
the Internet on the inside of the back cover.
￭

Compliance with the European EMC Directive

The EMC Directive defines the requirements for immunity and emissions of
electrical equipment used within the European Union. The EMC product standard
(EN 61800- 3:2004 + A1:2012) covers requirements stated for drives. See section
Compliance with the EN 61800-3:2004 + A1:2012
conformity (3AXD10000302784) is available on the Internet. See section Document
library on the Internet on the inside of the back cover.
￭

Compliance with the European ROHS II Directive 2011/65/EU

The RoHS II Directive defines the restriction of the use of certain hazardous
substances in electrical and electronic equipment. The declaration of conformity
(3AXD10000302784) is available on the Internet. See section Document library on
the Internet on the inside of the back cover.
￭

Compliance with the European WEEE Directive 2002/96/EC

The WEEE Directive defines the regulated disposal and recycling of electric and
electrical equipment.
￭
Compliance with the European Machinery Directive 2006/42/EC
2nd Edition – June 2010
The drive is a machinery component that can be integrated into a wide range of
machinery categories as specified in European Commission's Guide to application
of the Machinery Directive 2006/42/EC 2nd Edition – June 2010 . See chapter
Safe torque off function (page 409).
below. The declaration of
The