Enabling And Disabling Parksense - Jeep GLADIATOR 2020 Owner's Manual

Front Distance Greater than 47 inches
(inches / cm)
Arcs — Left
Arcs — Center
Arcs — Right
Audible Alert Chime
Radio Volume Reduced
NOTE:
ParkSense will reduce the volume of the radio,
if on, when the system is sounding an audio
tone.
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately three
seconds when an obstacle has been detected,
the vehicle is stationary, and the brake pedal is
applied.
Adjustable Chime Volume Settings
The Front and Rear chime volume settings are
programmable.
WARNING ALERTS FOR FRONT
47-39 inches
(120 cm) (120-100 cm)
None None
None 4th Solid
None None
None None
No No
The settings may be programmed through the
Uconnect System. Refer to "Uconnect Settings"
in "Multimedia" for further information.
The chime volume settings include low,
medium, and high. The factory default volume
setting is medium.
ParkSense will retain its last known
configuration state through ignition cycles.
E A
NABLING
ParkSense can be enabled and disabled with
the ParkSense switch.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster display will show the
"PARKSENSE OFF" message for
39-25 inches
(100-65 cm)
None
3rd Flashing
None
None
No
D P S
ND ISABLING ARK ENSE
STARTING AND OPERATING
25-12 inches Less than 12 inches
(65-30 cm) (30 cm)
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
Fast Continuous
Yes
approximately five seconds. Refer to
"Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further
information.
When the gear selector is moved to REVERSE
and the system is disabled, the instrument
cluster display will show the "PARKSENSE OFF"
message for as long as the vehicle is in
REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and the system requires service, the
switch LED will blink momentarily, and then the
LED will be on.
251
Yes
5