Depleted Key Fob Battery - Jeep GLADIATOR 2020 Owner's Manual

WARNING!
Before exiting a vehicle, always come to a

complete stop, then shift the automatic
transmission into PARK, apply the parking
brake, place the engine in the OFF position,
and remove the key fob from the vehicle
and lock your vehicle. If equipped with
Keyless Enter-N-Go, always make sure the
keyless ignition is in the OFF position,
remove the key fob from the vehicle and
lock the vehicle.
Never leave children alone in a vehicle, or

with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-

tended is dangerous for a number of
reasons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
Do not leave the key fob in or near the

vehicle, or in a location accessible to chil-
dren, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-Go
in the ON/RUN mode. A child could operate
power windows, other controls, or move the
vehicle.
WARNING! (Continued)
Do not leave children or animals inside

parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
An unlocked vehicle is an invitation for
thieves. Always remove key fob from the
vehicle and lock all doors when leaving the
vehicle unattended.
D K
EPLETED EY
In case the ignition switch does not change with
the push of a button, the key fob may have a low
or fully depleted battery. A low key fob battery
can be verified by referring to the instrument
cluster, which will display directions to follow.
(Continued)
CAUTION!
F B
OB ATTERY
GETTING TO KNOW YOUR VEHICLE
NOTE:
A low key fob battery condition may be indicated
by a message in the instrument cluster display,
or by the LED light on the key fob. If the LED key
fob light no longer illuminates from key fob
button pushes, then the key fob battery requires
replacement.
In this situation, a backup method can be used
to operate the ignition switch. Put the nose side
of the key fob against the START/STOP ignition
button and push to operate the ignition switch.
Backup Starting Method
17
2