Steering Wheel; Tilt/Telescoping Steering Column; Heated Steering Wheel - If Equipped - Jeep GLADIATOR 2020 Owner's Manual

STEERING WHEEL

T /T S
ILT ELESCOPING TEERING
The Tilt/Telescoping Steering Column feature
allows the steering column to tilt upward or
downward, and lengthen or shorten the steering
column. The Tilt/Telescoping lever is located on
the steering column, below the turn signal lever.
Tilt/Telescoping Steering Column Lever
To unlock the steering column, push the Tilt/
Telescoping lever downward (toward the floor).
To tilt the steering column, move the steering
wheel upward or downward as desired.
To lengthen or shorten the steering column, pull
the steering wheel outward or push it inward as
desired.
To lock the steering column in position, pull the
Tilt/Telescoping lever upward until fully
C
OLUMN engaged.
Do not adjust the steering column while
driving. Adjusting the steering column while
driving or driving with the steering column
unlocked, could cause the driver to lose
control of the vehicle. Failure to follow this
warning may result in serious injury or death.
H S
EATED TEERING
E
QUIPPED
The steering wheel contains a heating element
that will warm the steering wheel in cold
weather. The heated steering wheel has only
one temperature setting. Once the heated
steering wheel has been turned on, it will stay
on until the operator turns it off. The heated
steering wheel may not turn on when it is
already warm.
WARNING!
W — I
HEEL F
GETTING TO KNOW YOUR VEHICLE
The heated steering wheel control button is
located on the center of the instrument panel
below the touchscreen and within the climate or
controls screen of the touchscreen.
Push the heated steering wheel button once

to turn the heating element on.
Push the heated steering wheel button a

second time to turn the heating element off.
NOTE:
The engine must be running for the heated
steering wheel to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start,
the heated steering wheel can be programmed
to come on during a remote start.
This feature can be programmed through the
Uconnect system. Refer to "Uconnect Settings"
in "Multimedia" for further information.
41
2