Jeep GLADIATOR 2020 Owner's Manual page 286

284 IN CASE OF EMERGENCY
10. Remove connector from bulb.
11. Push connector onto new bulb base, and
push the connector locking tab to the lock
position.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb a
quarter turn clockwise.
Front Park/Turn Signal
NOTE:
We advise referring to an authorized dealer for
service.
1. Remove the front wheel liner fasteners to
access bulb sockets.
Wheel Liner
2. Turn the socket assembly a quarter turn
counterclockwise and remove from
housing. Pull the bulb straight from the
socket to replace.
LED Front Side Marker
1. Remove the front wheel liner fasteners to
access side maker screw and electrical
connector.
2. Remove fastening screw in the back of the
front side maker assembly and disconnect
electrical connector.
3. Remove and replace LED front side marker
light assembly.
Halogen Front Fog Lamp
NOTE:
We advise referring to an authorized dealer for
service.
1. Reach under the vehicle to access the
back of the front fog lamp.
2. Disconnect the wire harness connector
from the front fog lamp connector
receptacle.
3. Firmly grasp the bulb by the two latch
features and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect
the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.