Warning Lights And Messages; Red Warning Lights - Jeep GLADIATOR 2020 Owner's Manual

120 GETTING TO KNOW YOUR INSTRUMENT PANEL
What to do when an electrical load reduction
action message is present ("Battery Saver On"
or "Battery Saver Mode")
During a trip:
Reduce power to unnecessary loads if

possible:
Turn off redundant lights (interior or exte-

rior)
Check what may be plugged in to power

outlets +12 Volt, 115 Volts AC, USB ports
Check HVAC settings (blower, tempera-

ture)
Check the audio settings (volume)

After a trip:
Check if any aftermarket equipment was

installed (additional lights, upfitter electrical
accessories, audio systems, alarms) and
review specifications if any (load and ignition
off draw currents).
Evaluate the latest driving cycles (distance,

driving time and parking time).
The vehicle should have service performed if

the message is still present during consecu-
tive trips and the evaluation of the vehicle
and driving pattern did not help to identify the
cause.

WARNING LIGHTS AND MESSAGES

The warning/indicator lights will illuminate in
the instrument panel together with a dedicated
message and/or acoustic signal when
applicable. These indications are indicative and
precautionary and as such must not be
considered as exhaustive and/or alternative to
the information contained in the Owner's
Manual, which you are advised to read carefully
in all cases. Always refer to the information in
this chapter in the event of a failure indication.
All active telltales will display first if applicable.
The system check menu may appear different
based upon equipment options and current
vehicle status. Some telltales are optional and
may not appear.
R W L
ED ARNING IGHTS
Air Bag Warning Light
This warning light will illuminate to
indicate a fault with the air bag, and
will turn on for four to eight seconds
as a bulb check when the ignition is
placed in the ON/RUN or ACC/ON/RUN
position. This light will illuminate with a single
chime when a fault with the air bag has been
detected, it will stay on until the fault is cleared.
If the light is either not on during startup, stay
on, or turns on while driving, have the system
inspected at an authorized dealer as soon as
possible.
Brake Warning Light
This warning light monitors various
brake functions, including brake fluid
level and parking brake application. If
the brake light turns on it may
indicate that the parking brake is applied, that
the brake fluid level is low, or that there is a
problem with the Anti-Lock Brake System
reservoir.