Jeep GLADIATOR 2020 Owner's Manual page 142

140 SAFETY
If equipped with Off Road+ and if Off Road+ is
active when "Full Off" mode is enabled by the
driver, ESC will not switch to "Partial Off" mode
at any speed and will remain in "Full Off" mode
until Off Road+ is exited or ESC is re-enabled by
the driver.
WARNING!
In the ESC "Full Off" mode, the engine

torque reduction and stability features are
disabled. Therefore, enhanced vehicle
stability offered by the ESC system is
unavailable. In an emergency evasive
maneuver, the ESC system will not engage
to assist in maintaining stability. ESC "Full
Off" mode is intended for off-highway or
off-road use only.
The Electronic Stability Control (ESC)

cannot prevent the natural laws of physics
from acting on the vehicle, nor can it
increase the traction afforded by prevailing
road conditions. ESC cannot prevent all
accidents, including those resulting from
excessive speed in turns, driving on very
slippery surfaces, or hydroplaning. ESC also
cannot prevent collisions.
ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the ignition
is placed in the ON/RUN mode. It
should go out with the engine running. If the
"ESC Activation/Malfunction Indicator Light"
comes on continuously with the engine running,
a malfunction has been detected in the ESC
system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater
than 30 mph (48 km/h), see an authorized
dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator
Light" (located in the instrument cluster) starts
to flash as soon as the tires lose traction and
the ESC system becomes active. The "ESC
Activation/Malfunction Indicator Light" also
flashes when the Traction Control System (TCS)
is active. If the "ESC Activation/Malfunction
Indicator Light" begins to flash during
acceleration, ease up on the accelerator and
apply as little throttle as possible. Be sure to
adapt your speed and driving to the prevailing
road conditions.
NOTE:
The "ESC Activation/Malfunction Indicator

Light" and the "ESC OFF Indicator Light"
come on momentarily each time the ignition
is placed in the ON/RUN mode.
Each time the ignition is placed in the ON

position, the ESC system will be on even if it
was turned off previously.
The ESC system will make buzzing or clicking

sounds when it is active. This is normal; the
sounds will stop when ESC becomes inactive
following the maneuver that caused the ESC
activation.
The "ESC OFF Indicator Light"
indicates the customer has elected to
have the Electronic Stability Control
(ESC) in a reduced mode.