Jeep GLADIATOR 2020 Owner's Manual page 300

298 IN CASE OF EMERGENCY
Warning Label
CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated.
1. Remove the spare tire, jack and tools from
the stored location.
2. Using the lug wrench, loosen the wheel nuts
(but do not remove) by turning them
counterclockwise one turn while the wheel
is still on the ground.
3. Assemble the jack and jacking tools.
Connect the jack handle driver to the
extension, then to the lug wrench.
Assembled Jack And Tools
4. Operate the jack from the front or the rear of
the vehicle. Place the jack under the axle
tube, as shown. Do not raise the vehicle
until you are sure the jack is fully engaged.
Front Jack Lifting Point
Front Jacking Location
Rear Jack Lifting Point