To Manually Turn Off The Stop/Start; System; To Manually Turn On The Stop/Start System; System Malfunction - Jeep GLADIATOR 2020 Owner's Manual

T M T O T
O ANUALLY URN FF
S S
TART YSTEM
1. Push the Stop/Start Off switch (located on
the switch bank). The light on the switch
will illuminate.
Stop/Start OFF Switch
2. The STOP/START OFF message will appear
in the instrument cluster. Refer to
"Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further
information.
3. At the next vehicle stop (after turning off the
Stop/Start system), the engine will not be
stopped.
S /
4. If the Stop/Start system is manually
HE TOP
switched off, the engine can only be started
and stopped by cycling the ignition switch.
5. The Stop/Start system will reset itself back
to an ON condition every time the ignition is
cycled off and back on.
T M
O ANUALLY
S S
TART YSTEM
Push the Stop/Start Off switch (located on the
switch bank). The light on the switch will turn
off.
S M
YSTEM ALFUNCTION
If there is a malfunction in the Stop/Start
system, the system will not shut down the
engine. A "SERVICE STOP/START SYSTEM"
message will appear in the instrument cluster
display. Refer to "Instrument Cluster Display" in
"Getting to Know Your Instrument Panel" for
further information.
If the "SERVICE STOP/START SYSTEM"
message appears in the instrument cluster
display, have the system checked by an
authorized dealer.
T O T S /
URN N HE TOP
STARTING AND OPERATING
SPEED CONTROL — IF EQUIPPED
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
20 mph (32 km/h).
The Speed Control buttons are located on the
right side of the steering wheel.
Speed Control Buttons
1 — SET (+)/Accel
2 — On/Off
3 — RES/Resume
4 — SET (-)/Decel
5 — CANC/Cancel
NOTE:
In order to ensure proper operation, the Speed
Control System has been designed to shut down
if multiple Speed Control functions are operated
227
5