Parksense Warning Display; Enabling And Disabling Parksense; Service The Parksense Park Assist System - Jeep GRAND CHEROKEE 2023 Owner's Manual

NOTE:
ParkSense will reduce the volume of the radio, if on, when
the system is sounding an audio tone.
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist audible alert
(chime) after approximately three seconds when an
obstacle has been detected, and the vehicle is stationary.
Adjustable Chime Volume Settings
Front and rear chime volume settings can be selected
from the Uconnect system page 168.
Ú
The chime volume settings include low, medium, and high.
ParkSense will retain its last known configuration state
through ignition cycles.
P S W D
ARK ENSE ARNING ISPLAY
The ParkSense Warning screen is located within the
instrument cluster display page 84. It provides visual
Ú
warnings to indicate the distance between the rear fascia/
bumper and/or front fascia/bumper and the detected
obstacle.
E A D
NABLING ND ISABLING
ParkSense can be enabled and disabled with
the ParkSense switch located on the switch
panel above the Uconnect display.
When the ParkSense switch is pushed to enable the
system, the instrument cluster will display the system
state.
When the ParkSense switch is pushed to disable the
system, the instrument cluster will display the
"PARKSENSE OFF" message for approximately two
seconds. When the gear selector is moved to REVERSE
and the system is disabled, the instrument cluster display
will display the "PARKSENSE OFF" message for as long as
the vehicle is in REVERSE.
NOTE:
When ParkSense is disabled and the gear selector is
moved to the DRIVE position, no warning message will be
displayed.
The ParkSense switch LED will be on when ParkSense is
disabled or requires service. The ParkSense switch LED
will be off when the system is enabled. If the ParkSense
switch is pushed, and the system requires service, the
ParkSense switch LED will blink momentarily, and then the
LED will be on.
P S S T
ARK ENSE ERVICE HE
S
YSTEM
During vehicle start-up, when the ParkSense system has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display a pop-up. The pop-up will include up to two faults.
Possible fault messages are "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS", "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS", or "PARKSENSE UNAVAILABLE
SERVICE REQUIRED." The pop-up message will display for
five seconds.
When the gear selector is moved to REVERSE and the
system has detected a faulted condition, the instrument
cluster display will display a "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS", "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS" or "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" pop-up message for five seconds. After five
seconds, a vehicle graphic will be displayed with
"UNAVAILABLE" at either the front or rear sensor location
depending on where the fault is detected. The system will
continue to provide arc alerts for the side that is functioning
properly. These arc alerts will interrupt the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS", "PARKSENSE
UNAVAILABLE WIPE FRONT SENSORS", or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" messages if an object is
detected within the five second pop-up duration.
STARTING AND OPERATING 143
P S P A
ARK ENSE ARK SSIST