Garage Door Opener (Homelink®) - If; Equipped; Before You Begin Programming; Homelink - Jeep GLADIATOR 2020 Owner's Manual

GARAGE DOOR OPENER (HOMELINK®) — IF

EQUIPPED

Scan this QR code for your digital
experience.
HomeLink® replaces up to three hand-held
transmitters that operate devices such as
garage door openers, motorized gates, lighting
or home security systems. The HomeLink® unit
is powered by your vehicle's 12 Volt battery.
The HomeLink® buttons, located on the sun visor
or the overhead console, designate the three
different HomeLink® channels. The HomeLink®
indicator is located above the center button.
HomeLink® Buttons
To operate HomeLink®, push and release any
of the programmed HomeLink® buttons. These
buttons will activate the devices they are
programmed to with each press of the
corresponding HomeLink® button.
NOTE:
HomeLink® is disabled when the Vehicle Secu-
rity Alarm is active.
B Y B P
EFORE OU EGIN ROGRAMMING
H L ®
OME INK
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accurate
transmission of the radio-frequency signal it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
Make sure your hand-held transmitter is
programmed to activate the device you are
trying to program your HomeLink® button to.
GETTING TO KNOW YOUR VEHICLE
To erase the channels, place the ignition in the
ON/RUN position, and push and hold the two
outside HomeLink® buttons (I and III) for up to
20 seconds or until the orange indicator
flashes.
NOTE:
Erasing all channels should only be

performed when programming HomeLink®
for the first time. Do not erase channels when
programming additional buttons.
If you have any problems, or require assis-

tance, please call toll-free 1-800-355-3515
or, on the Internet at HomeLink.com for infor-
mation or assistance.
91
2