Vehicle Security Alarm - If Equipped; To Arm The System; To Disarm The System - Jeep GLADIATOR 2020 Owner's Manual

22 GETTING TO KNOW YOUR VEHICLE
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic
Development applicables aux appareils radio
exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes:
1. l'appareil ne doit pas produire de
brouillage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compro-
mettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no
cause interferencia perjudicial y
2. este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user's authority to operate
the equipment.
VEHICLE SECURITY ALARM — IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors for unauthorized entry and the ignition
switch for unauthorized operation. When the
alarm is activated, the interior switches for door
locks are disabled. The Vehicle Security Alarm
provides both audible and visible signals. If
something triggers the alarm, the Vehicle Security
Alarm will provide the following audible and visible
signals: the horn will pulse, the park lamps and/or
turn signals will flash, and the vehicle security
light in the instrument cluster will flash.
T A T S
O RM HE YSTEM
Follow these steps to arm the Vehicle Security
Alarm:
1. Make sure the vehicle's ignition is placed
in the OFF position. Refer to "Starting The
Engine" in "Starting And Operating" for
further information.
2. Perform one of the following methods to
lock the vehicle:
Push the lock button on the interior

power door lock switch with the driver
and/or passenger door open.
Push the lock button on the exterior

Passive Entry door handle with a valid key
fob available in the same exterior zone.
Refer to "Keyless Enter-N-Go — Passive
Entry" in "Doors" in this chapter for
further information.
Push the lock button on the key fob.

3. If any doors are open, close them.
NOTE:
The Vehicle Security Alarm will not arm if you
lock the doors using the manual door lock.
T D T S
O ISARM HE YSTEM
The Vehicle Security Alarm can be disarmed
using any of the following methods:
Push the unlock button on the key fob.

Grasp the Passive Entry Unlock door handle

(if equipped). Refer to "Keyless Enter-N-Go —
Passive Entry" in "Doors" in this chapter for
further information.
Cycle the vehicle ignition system out of the

OFF position.