Jeep GLADIATOR 2020 Owner's Manual page 77

CAUTION!
Do not overtighten Torx fasteners. Damage to
the retainers will occur.
Step One
1 — Rear Fasteners
2 — Corner Fasteners
2. Install the door frames. Start with both front
doors, followed by both rear doors. Refer to
"Door Frame" in this chapter for
instructions and appropriate torque specifi-
cations for the door frame Torx head
fasteners.
CAUTION!
Failure to follow the next steps could result in
damage to the soft top or vehicle.
3. Unsnap and remove the storage bag. This
bag should be discarded. It was intended as
a protective cover for shipping only.
4. Ensure the top is secured with the provided
hook-and-loop fasteners, then lift the soft
top onto the rear of the cab. Line up the
locater pins (one on each side of the soft
top) with the rear door frames.
Step Four
GETTING TO KNOW YOUR VEHICLE
5. Using the provided #T50 Torx head driver
and ratchet, install and tighten the Torx
fasteners by turning them clockwise.
Secure them until they are snug, being
careful not to cross-thread the fasteners or
overtighten. Refer to the following table for
recommended torque specifications.
Repeat on the opposite side.
Step Five
Torque
Specification
Maximum
For Torx
Fasteners
119.5 in-lbs 150.5 in-lbs
(13.5 N·m) (17.0 N·m)
75
2
Minimum
106.2 in-lbs
(12.0 N· m )