Rear Head Restraints - Jeep GLADIATOR 2020 Owner's Manual

40 GETTING TO KNOW YOUR VEHICLE
R H R
EAR EAD ESTRAINTS
The rear seat is equipped with nonadjustable,
but foldable, outboard head restraints, as well
as an adjustable, removable center head
restraint.
To fold down the outboard head restraints, push
the button located on the outboard side of the
head restraint.
Rear Foldable Outboard Head Restraints
To return the head restraint to its upward
position, lift up on the head restraint until it
locks into place.
To raise the center head restraint, lift up on the
head restraint. To lower the center head
restraint, push the adjustment button, located
at the base of the head restraint, and push
down on the head restraint.
To remove the center head restraint, raise it as
far as it can go. Then, push the adjustment
button and the release button at the base of
each post while pulling the head restraint up.
To reinstall the head restraint, put the head
restraint posts into the holes and push
downward. Then, adjust it to the appropriate
height using the adjustment button. Refer to
"Occupant Restraint Systems" in "Safety" for
information on child seat tether routing.
NOTE:
Lower the center head restraint to avoid contact
with the center console when folding the seat
down.
WARNING!
Do not drive the vehicle without the rear

seat head restraints installed while passen-
gers are occupying the rear seat. In a colli-
sion, people riding in this area without the
head restraints installed are more likely to
be seriously injured or killed.
A loose head restraint thrown forward in a

collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head
restraints in a location outside the occu-
pant compartment.
ALL the head restraints MUST be rein-

stalled in the vehicle to properly protect the
occupants. Follow the reinstallation instruc-
tions above prior to operating the vehicle or
occupying a seat.