Automatic Mode - Jeep GLADIATOR 2020 Owner's Manual

Hide thumbs Also See for GLADIATOR 2020:
Table of Contents

Advertisement

Secondary Battery
Your vehicle may be equipped with a secondary
battery used to power the Stop/Start system
and the 12 Volt vehicle electrical system. The
secondary battery is located behind the wheel
well for the front passenger wheel.
Battery Locations
1 — Primary Battery
2 — Secondary Battery
A
M
UTOMATIC
ODE
WARNING!
Vehicles with the Stop/Start system will be
equipped with two batteries. Both the main
and the supplemental batteries must be
disconnected to completely de-energize the
12 Volt electrical system.
Serious injury or death could result if you do
not disconnect both batteries. To learn how
to properly disconnect, see an authorized
dealer.
The Stop/Start feature is enabled
after every normal customer engine
start. It will remain in STOP/START
NOT READY until you drive forward
with a vehicle speed greater than 5 mph
(8 km/h). At that time, the system will go into
STOP/START READY and if all other conditions
are met, can go into an STOP/START AUTO STOP
ACTIVE mode.
STARTING AND OPERATING
To Activate The STOP/START AUTO STOP
ACTIVE Mode, The Following Must Occur:
The system must be in STOP/START READY
state. A STOP/START READY message will be
displayed in the instrument cluster. Refer to
"Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further
information.
Vehicle speed must be less than 2 mph
(3 km/h).
The gear selector must be in the NEUTRAL
position and the clutch pedal must be fully
released.
The engine will shut down, the tachometer will
fall to the Stop/Start position, the STOP/START
AUTO STOP ACTIVE message will appear, and
the heater/air conditioning (HVAC) air flow will
be reduced.
225
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents