Enabling And Disabling Parksense - Jeep WRANGLER 2023 Owner's Manual

156 STARTING AND OPERATING
The vehicle is close to the obstacle when the warning display shows one flashing arc and sounds a continuous tone. The following chart shows the warning alert operation when
the system is detecting an obstacle:
Greater than
Rear Distance
79 inches
(inches/cm)
(200 cm)
Arcs — Left None
Arcs — Center None
Arcs — Right None
Audible Alert
None
Chime
Radio Volume
No
Reduced
NOTE:
ParkSense will reduce the volume of the radio, if on, when the system is sounding an audio tone.
ENABLING AND DISABLING
PARKSENSE
ParkSense can be enabled and disabled
with the ParkSense switch located below the
Uconnect display.
When the ParkSense switch is pushed to
disable the system, the instrument cluster display
page 105 will show the "PARKSENSE OFF" mes-
sage for approximately five seconds. When the gear
selector is moved to REVERSE and the system is dis-
abled, the instrument cluster display will show the
"PARKSENSE OFF" message for as long as the vehicle
is in REVERSE (Not in 4WD Low).
WARNING ALERTS
79-59 inches 59-47 inches
(200-150 cm) (150-120 cm)
None None
6th Solid 5th Solid
None None
Single 1/2
Second Tone Slow
(for rear center (for rear center only)
only)
Yes Yes
The ParkSense switch LED will be on when ParkSense
is disabled or requires service. The ParkSense switch
LED will be off when the system is enabled. If the
ParkSense switch is pushed, and requires service, the
ParkSense switch LED will blink momentarily, and then
the LED will remain on.
47-39 inches 39-25 inches
(120-100 cm) (100-65 cm)
None None
4th Solid 3rd Flashing
None None
Slow Fast
(for rear center (for rear center
only) only)
Yes Yes
25-12 inches Less than
(65-30 cm) 12 inches (30 cm)
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
Fast Continuous
Yes Yes