Hard Top Front Panel(S) Installation; Removing The Hard Top - Jeep GLADIATOR 2020 Owner's Manual

3. Insert the right side Freedom Top panel into
the bag with the latches facing downward.
NOTE:
Ensure the front panel latch is closed prior to
inserting the panel into the bag.
4. Unfold the outer flap and zip the hard top
bag closed.
Step Four
5. Store the Freedom Top panels bag in a safe
location.
H T F P (
ARD OP RONT ANEL S
I
NSTALLATION
1. Set the right side panel on the windshield
frame with the locating pin in the front
receiver mounting hole, followed by the left
side panel, making sure there is no
overhang. Make sure that the panels are
sitting flush with the body.
2. Secure the panel(s) using the same steps
for removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top
panels should be clear of any dust and debris
prior to reinstallation.
R T H T
EMOVING HE ARD OP
1. Remove both front panels. Refer to "Hard
Top Front Panel(s) Removal" in this section
for removal instructions.
2. Open both front doors.
GETTING TO KNOW YOUR VEHICLE
)
3. Using the provided #50 Torx head driver
and ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors).
79
2
Step Three