Jeep GLADIATOR 2020 Owner's Manual page 146

144 SAFETY
The cluster icon and switch lamp will flash for

several seconds then extinguish when the
driver pushes the SSC switch but enabled
conditions are not met.
The cluster icon and switch lamp will flash for

several seconds then extinguish when SSC
disables due to excess speed.
The cluster icon and switch lamp will flash

then extinguish when SSC deactivates due to
overheated brakes.
WARNING!
SSC is only intended to assist the driver in
controlling vehicle speed when driving in
off-road conditions. The driver must remain
attentive to the driving conditions and is
responsible for maintaining a safe vehicle
speed.
Trailer Sway Control (TSC)
Trailer Sway Control (TSC) uses sensors in the
vehicle to recognize an excessively swaying
trailer and will take the appropriate actions to
attempt to stop the sway. TSC will become
active automatically once an excessively
swaying trailer is recognized.
NOTE:
TSC cannot stop all trailers from swaying.
Always use caution when towing a trailer and
follow the trailer tongue weight recommenda-
tions. Refer to "Trailer Towing" in "Starting and
Operating" for further information.
When TSC is functioning, the "ESC Activation/
Malfunction Indicator Light" will flash, the
engine power may be reduced, and you may feel
the brakes being applied to individual wheels to
attempt to stop the trailer from swaying. TSC is
disabled when the ESC system is in the "Partial
Off" or "Full Off" modes.
WARNING!
If TSC activates while driving, slow the vehicle
down, stop at the nearest safe location, and
adjust the trailer load to eliminate trailer
sway.
Traction Control System (TCS)
The Traction Control System (TCS) monitors the
amount of wheel spin for each of the driven
wheels. If wheel spin is detected, the TCS may
apply brake pressure to the spinning wheel(s)
and/or reduce engine power to provide
enhanced acceleration and stability. A feature
of the TCS, Brake Limited Differential (BLD),
functions similar to a limited slip differential
and controls the wheel spin across a driven
axle. If one wheel on a driven axle is spinning
faster than the other, the system will apply the
brake of the spinning wheel. This will allow more
engine torque to be applied to the wheel that is
not spinning. BLD may remain enabled even if
TCS and ESC are in a reduced mode.