Axle Lock (Tru-Lok) Rear Only - If Equipped; Electronic Sway Bar Disconnect - If Equipped - Jeep GLADIATOR 2020 Owner's Manual

218 STARTING AND OPERATING
To activate the system, push the AXLE LOCK
switch down to lock the rear axle only (the
"REAR ONLY" will illuminate), push the switch
up to lock the front axle and rear axle (the
"FRONT + REAR" will illuminate). When the rear
axle is locked, pushing the bottom of switch
again will lock or unlock the front axle.
NOTE:
The indicator lights will flash until the axles are
fully locked or unlocked.
To unlock the axles, push the AXLE LOCK OFF
button.
Axle lock will disengage if the vehicle is taken
out of 4L (Four-Wheel Drive Low Range), or the
ignition switch is turned to the OFF position.
The axle lock disengages at speeds above
30 mph (48 km/h), and will automatically
re-lock once vehicle speed is less than 10 mph
(16 km/h).
A L (T -L ) R
XLE OCK RU OK EAR
E
QUIPPED
The AXLE LOCK switch is located on the
instrument panel (to the right of the steering
column).
Axle Lock Switch Panel
This feature will only activate when the following
conditions are met:
Ignition in RUN position, vehicle in 4L

(Four-Wheel Drive Low Range).
Vehicle speed should be 10 mph (16 km/h)

or less.
Both right and left wheels on the axle are at

the same speed.
O — I
To activate the rear system, push the AXLE
NLY F
LOCK switch down to lock the rear axle only (the
"REAR ONLY" will illuminate).
NOTE:
The indicator lights will flash until the axle is
fully locked or unlocked.
To unlock the axle, push the AXLE LOCK OFF
button.
Axle lock will disengage if the vehicle is taken
out of 4L (Four-Wheel Drive Low Range), or the
ignition switch is turned to the OFF position.
The axle lock disengages at speeds above
30 mph (48 km/h), and will automatically
re-lock once vehicle speed is less than 10 mph
(16 km/h).
E
LECTRONIC
I E
F QUIPPED
Your vehicle may be equipped with an
electronic disconnecting stabilizer/sway bar.
This system allows greater front suspension
travel in off-road situations.
This system is controlled by the SWAY BAR
switch located on the instrument panel (to the
right of the steering column).
S B D —
WAY AR ISCONNECT