Jeep GLADIATOR 2020 Owner's Manual page 83

7. To release the wire harness, pull back on
the red latch (1), then push down on the
black button (2) while pulling the harness
out.
Step Seven
1 — Red Latch
2 — Black Button
8. Remove the hard top from the vehicle.
Install the provided edge protectors along
the bottom edges of the hard top, and place
the hard top on a soft surface to prevent
damage.
CAUTION!
The removal of the Freedom Top requires four
adults located on each corner. Failure to
follow this caution could damage the
Freedom Top.
9. Store the wire harness by removing the
storage cover on the quarter trim. Use the
mechanical key blade to pry the cover open.
Step Nine
10. Tuck the wire harness inside the storage
compartment, and replace the cover.
GETTING TO KNOW YOUR VEHICLE
Step Ten
CAUTION!
The front panel(s) must be positioned prop-

erly to ensure sealing. Improper installation
can cause water to leak into the vehicle's
interior.
The hard top assembly must be positioned

properly to ensure sealing. Improper instal-
lation can cause water to leak into the
vehicle's interior.
81
2
(Continued)