Jeep GLADIATOR 2020 Owner's Manual page 88

86 GETTING TO KNOW YOUR VEHICLE
2. Manually remove the protective caps over
the windshield wiper hex bolts.
Step Two
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
3. Using the provided 15 mm socket, remove
the two hex bolts and remove the wiper
arms.
4. Move to the inside of the vehicle and lower
both sun visors.
5. Using the provided #T40 Torx head driver,
remove the four Torx head fasteners
located along the interior of the windshield
(two on each side of the header trim).
Step Five
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping, or
in the fastener bin located below the rear seat.
6. Lower the windshield gently until it contacts
the tie-down bumpers (if equipped).
Step Six
1 — Washer Nozzle
2 — Bumper
3 — Tie-Down
7. Secure the windshield by passing a cinch
strap through the tie-down bumpers on
either side of the hood and on the
windshield frame. Tighten the strap to
secure the windshield in place.
CAUTION!
Do Not Overtighten! Damage to the
windshield could result.