Jeep GLADIATOR 2020 Owner's Manual page 82

80 GETTING TO KNOW YOUR VEHICLE
4. If equipped, remove the lower interior soft
trim panel (attached by the hook-and-loop
fastener) by pulling the panel away from the
trim.
Step Four
5. Remove the Torx head fasteners that
secure the hard top to the vehicle: two along
the interior bodyside, rearward of the back
doors, followed by the four fasteners along
the back of the vehicle cab using the
#T50 Torx head driver.
Step Five
1 — Bodyside Torx Head Fasteners
2 — Vehicle Cab Torx Head Fasteners
6. Locate the wire harness on the left rear
inside corner of the vehicle. To access the
harness, remove the plastic cover by
pushing the cover to the side, and sliding it
off.
NOTE:
Do not force open; this will break the plastic
cover.
Step Six