Jeep GLADIATOR 2020 Owner's Manual page 74

72 GETTING TO KNOW YOUR VEHICLE
Installing The Rear Window And Quarter
Panel Cover Assemblies
NOTE:
Both quarter panel cover assemblies and the
rear window must ALL be removed together, or
installed together.
If the rear window and quarter panel cover
assemblies were previously removed, proceed
as follows to install:
1. Guide the top of the quarter panel cover
assembly up into the retainer.
Step One
CAUTION!
Failure to follow all quarter panel cover
assembly and rear window install steps could
result in damage to the Soft Top or vehicle.
2. Engage the plastic retainers on the front of
the cover assembly (toward the front of the
vehicle) starting at the top, and working
downward.
Step Two
NOTE:
It is critical that the retainers are fully engaged
before the vehicle resumes motion.
3. Secure the hook-and-loop fastener at the
upper front corner of each quarter panel
cover assembly by pressing firmly.
Step Three
4. From either side, guide the rear window into
the retainer while keeping the window level.
Step Four