Table of Contents
Advertisement
Installing the handset option for the M3905 Call Center
Telephone
Figure 111
Removal of the Hook Switch Cover
Front view
3
Lower the Module into place, and insert the 10-pin plug on the Module into
the 10-pin slot on the telephone. Push in gently until the retaining tabs
snap into place.
4
Insert the clips on the telephone into the hinges on the footstand, then
press on the front of the footstand until it snaps into place.
5
While depressing the telephone tilt handle, swing the footstand into the
desired position, then release the handle.
6
Carefully turn the new assembly upright.
The Handset Kit is a hardware option for the M3905 Call Center Telephone.
The handset does not accompany the M3905 Call Center Telephone. The
handset can be added to the M3905 by removing the front plate of the
telephone.
Note: Nortel Networks recommends that a systems administrator
complete this installation.
553-AAA0672
M3900 installation and configuration
Telephones and Consoles
Page 409 of 532
553-AAA0673
Rear view
Description
Advertisement
Table of Contents
