Table of Contents
Advertisement
Removing the M2250 attendant console
Follow the steps in Procedure 39 if it is necessary to remove an M2250
attendant console.
Procedure 39
Removing the M2250 attendant console
1
Remove related attendant console data from the system memory. Refer
to the Software Input/Output: Administration (553-3001-311).
2
Locate and remove cross-connections from the attendant console cable
at the cross-connect terminal. See Procedure 44 on
3
Remove the circuit card if required. Refer to Circuit Card: Description and
Installation (553-3001-211).
Note: Do not remove the circuit card if any of the remaining units on the
card are assigned.
4
Disconnect the Amphenol connector on the end of the cable leading to the
cross-connect terminal from the connector on the cable leading to the
attendant console.
5
Pack the attendant console, handset, and cords in a suitable container.
Removing the M2250 attendant console top cover
Follow the steps in Procedure 40 to remove the M2250 Attendant top cover.
Procedure 40
Removing the M2250 attendant console top cover
1
Disconnect any plugs and cords from the attendant console.
2
Remove the ten 10-mm fastening screws in the flange of the attendant
console, as well as one 10-mm and one 40-mm screw on the base of the
attendant console. See Figure 63 for the M2250 assembly drawing.
M1250 and M2250 Attendant Consoles
End of Procedure
Telephones and Consoles
Page 227 of 532
page
236.
Description
Advertisement
Table of Contents
