Table of Contents
Advertisement
M1250 and M2250 Attendant Consoles
3
Press the pound (#) to exit and return to Diagnostics menu 1.
Procedure 55
Toggling control gates
Use this procedure to turn the conference bridge analog control gates, the
auxiliary tone channel, and the Code Blue Relay ON or OFF. Note that the
auxiliary control only affects the control gate on the ASIP board. To actually
generate a tone, use the Alerter menu.
1
From Diagnostics menu 2, press "4."
DIAGNOSTICS: CONTROL
1. SCR
2. DST
{ 0 }
{ 0 }
* <OFF>
2
Follow the appropriate instruction below:
Press key "1" to toggle the primary control gate between ON and OFF.
Press key "2" to toggle the secondary control gate between ON and OFF.
Press key "3" to toggle the attendant receive control between ON and
OFF.
Press key "4" to toggle the attendant transmit control between ON and
OFF.
Press key "5" to toggle the auxiliary tone control between ON and OFF.
Press key "6" to toggle the relay control between ON and OFF.
3
Press the asterisk (*) to turn all the control gates OFF.
4
Press the octothorpe (#) to exit and return to Diagnostics menu 1.
Reset
To perform a hard reset of the console, from Diagnostics menu 2, press "5."
The reset is performed immediately. All devices and memory on the UIP and
End of Procedure
3. ARX
4. ATX
{ 0 }
{ 0 }
End of Procedure
Telephones and Consoles
Page 253 of 532
5. TON
6. REL
{ 0 }
{ 0 }
# <exit>
Description
Advertisement
Table of Contents
