Table of Contents
Advertisement
Page 120 of 532
Figure 28
Removing the top cover
On M1250 models remove
a) Flat cables (2 places)
b) Alerter connector
On M2250 models
remove flat cable
553-3001-367
Standard 1.00
7
Remove the knockout section on the back of the attendant console (see
Figure 29 on
page
any remnants of the breakaway tags.
8
Feed the flat ribbon cable for the Busy Lamp Field/Console Graphics
Module (BLF/CGM) through the knockout hole in the base of the
attendant console.
9
Hold the BLF/CGM unit over the console in a vertical position, ensuring
that the two locators on the bottom bracket of the BLF/CGM are located
in the knockout hole.
October 2003
121) with a small screwdriver or similar tool. Remove
Top cover
Base
553-AAA0628
Advertisement
Table of Contents
