Table of Contents
Advertisement
Page 408 of 532
Installing the Expansion KBA Footstand
Installing the Display-based Expansion Module
553-3001-367
Standard 1.00
3
Turn the completed assembly upright.
To install the Expansion KBA Footstand
1
Place the Single KBA Footstand and the Expansion KBA Footstand face
down on a flat surface.
2
Align the Expansion KBA Footstand with the Single KBA Footstand and
slide them together.
3
Insert two screws through the Expansion KBA Plate into the Single KBA
Footstand.
4
Tighten all four screws, ensuring that the two footstand assemblies are
properly aligned.
5
Insert the clips on the telephone and the Key-based Expansion Modules
into the hinges on the combined Single Expansion KBA Footstand
Assembly, and while squeezing the Module Tilt Handles, swing the
footstand into the desired position.
6
Turn the completed assembly upright.
The Display-based Expansion Module gives you three layers of eight
Programmable Line/Feature (soft-labeled) Keys. The Display-based
Expansion Module gives you a total of 24 Programmable Line/Feature Keys
(Key 32 through 55).
The Page button allows you to scroll to each key layer. The soft-labeled field
is 10 characters in length. You can customize the Display-based Expansion
labels using the program mode and the dial pad keys.
To install the Display-based Expansion Module:
1
While depressing the telephone tilt handle, pull the telephone away from
the footstand until it clears the final stop. Gently pull the footstand off the
clips.
2
Place the telephone and the Display-based Expansion Module face down
on a padded level surface, and align them.
October 2003
Advertisement
Table of Contents
