Table of Contents
Advertisement
Procedure 25
Connecting the data terminal
1
Connect the DB-25 connector-C interface connector from the data
terminal to the matching header connector in the back of the telephone.
2
Insert the two captive screws in the connector body into the threaded
holes in the header connector and secure tightly to prevent accidental
disconnection during data terminal operation.
Power Supply Board (NTZK models)
Use the following procedures to add a Power Supply Board to the telephone
for connection to a transformer or closet power supply. Use Procedure 26 for
the M2006 and M2008. USE Procedure 13 for the M2616, and M2216ACD.
Procedure 26
Installing and removing the M2006/M2008
Power Supply Board on NTZK sets
1
Remove the handset and place the telephone upside down on top of a
level, solid work surface (such as a desktop) covered with soft material or
paper to prevent damage to movable keys and the telephone face.
2
Disconnect all cords from the telephone.
M2000 add-on modules
End of Procedure
CAUTION
Damage to Equipment
Connect the optional Power Supply to the M2000
Series Meridian Digital Telephone only. Equipment
damage may result from incorrect connections. Both
the closet power supply and the transformer are for
use with the M2000 Series Meridian Digital
Telephone only.
CAUTION WITH ESDS DEVICES
Before handling internal telephone components,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
Telephones and Consoles
Page 149 of 532
Description
Advertisement
Table of Contents
