Table of Contents
Advertisement
Figure 45
Display cable routing
Set
Removing the display
8
Remove the two or three screws from the display module. Remove the
display from the telephone. To install the display option, go to step 11.
Installing the display board
9
Place the J1 connector of the display board over the P2 pins of the
telephone. See Figure 45 on
onto the P2 pins and is firmly seated.
10 Insert the self-tapping Phillips-head screw supplied with the display into
the mounting hole (near the top). Tighten it firmly with a #1 Phillips
screwdriver.
M2000 add-on modules
page
163. Press down slowly until J1 slides
Display
Board
Telephones and Consoles
Page 163 of 532
Display
Module
excess
cable
P4 pin
connector
mounting
hole
J1
connector ribbon
cable (fold)
J2 pin
connector
553-AAA0643
Description
Advertisement
Table of Contents
