Table of Contents
Advertisement
Page 178 of 532
553-3001-367
Standard 1.00
Removing the display board
6
The display board is located at the left center of the telephone. Disconnect
the display ribbon cable from the display board. Remove the small
mounting screw from the board. Grasp the board firmly on each end and
pull upward to remove it. To replace it, go to step 9.
Removing the display
7
The power supply board is located on the left side of the telephone.
Remove the two small screws from the power supply board (near the top)
and set them aside. Grasp the board firmly on each side. Carefully work
the board loose until released.
8
Remove the two or three screws from the display Module. Remove the
display from the telephone. To install the display, go to step 11.
Installing the display board
9
Place the J1 connector of the display board over the P4 pins of the
telephone (see Figure 50 on
onto the P4 pins and is firmly seated.
10 Insert the self-tapping Phillips-head screw supplied with the display into
the mounting hole (near the top). Tighten firmly with a #1 Phillips
screwdriver.
Installing the display
11 Place the display face-down near the top of the telephone and align the
two mounting holes of the display with the mounting holes in the
telephone.
12 Insert two self-tapping Phillips-head screws from the faceplate into the
mounting holes; tighten them firmly with a #1 Phillips screwdriver.
13 Install the power supply board (see Procedure 13 on
is not necessary on the M2616 unless there are other hardware options.
October 2003
page
176). Press down slowly until J1 slides
page
151). This step
Advertisement
Table of Contents
