Table of Contents
Advertisement
Page 252 of 532
553-3001-367
Standard 1.00
Procedure 52
Testing the Display
Use this procedure to check the functionality of the alphanumeric display
panel. Cycle through a number of different display patterns to check for visual
defects.
1
From Diagnostics menu 2, press "1."
2
Press the asterisk (*) to change the display screen pattern. Continue
changing the pattern until all the patterns have been cycled through.
3
Press the pound (#) to exit and return to Diagnostics menu 1.
Procedure 53
Displaying the firmware version numbers
Use this procedure to display the release and issue numbers of the firmware
installed on the UIP and ASIP microprocessor boards.
1
From Diagnostics menu 2, press "2." The display shows the firmware
release and issue numbers, as shown below:
DIAGNOSTICS:
2
Press the pound (#) to exit and return to Diagnostics menu 1.
Procedure 54
Displaying and resetting the QMT2 switch status
Use this procedure to display the current state of the QMT2 dip switch inside
the console and to change the setting for verification testing (LD 31). After a
change, the actual switch setting will return to its original state after a time-out
period of about three minutes.
1
From Diagnostics menu 2, press "3".
2
Press the asterisk (*) to toggle between QMT2 ON and OFF.
October 2003
End of Procedure
FIRMWARE
ASIP: XX XX
UIP: XX XX
End of Procedure
Advertisement
Table of Contents
