Table of Contents
Advertisement
Page 126 of 532
553-3001-367
Standard 1.00
8
Remove the top cover and place it upside down to the left of the attendant
console.
9
Pull back the snap-fits on the BLF/CGM to disengage the BLF/CGM from
the attendant console.
10 Place the top cover on the console. Slide it back and down into place (see
Figure 32 on
page
make sure that none are trapped.
11 Ensuring that the volume slider is fully engaged in the correct slider, hold
the top cover and console base firmly together. Turn the assembly upside
down (see Figure 33
12 Reinsert the 12 screws that secure the top cover to the console base and
tighten.
13 If required, replace the adjustable stand.
14 Reconnect the main system cable to the rear of the console.
Procedure 19
Checking the functionality of the Busy Lamp Field/Console Graphics
Module
Use this procedure to check the functionality of the Busy Lamp Field/Console
Graphics Module. Once in this menu, the dial pad is in CGM mode. When any
dial pad keys are pressed, except the pound (#) key, the keys are echoed on
the BLF/CGM Module.
1
From Diagnostics menu 1, press "5."
2
Press keys 0 through 9 and the asterisk (*) on the dial pad. Check the
CGM to see that they are echoed.
3
Press the pound (#) to exit and return to Diagnostics menu 1.
For more on the features and operation of the BLF/CGM, refer to the Busy
Lamp Field/Console Graphics Module User Guide.
October 2003
124). Reconnect all cables in the correct positions, and
page
125).
End of Procedure
End of Procedure
Advertisement
Table of Contents
