Table of Contents
Advertisement
Page 304 of 532
Handset Registration to Base Unit
Wall mounting the M2616CT
Specifications
Safety considerations
553-3001-367
Standard 1.00
Each M2616CT handset automatically registers with its respective base unit.
In cases where a substitute handset is required for troubleshooting purposes,
a different M2616CT handset can be re-registered by placing the different
handset on-hook, and unplugging, then re-plugging in the base unit's
ac power adapter and telephone line cord.
The M2616Ct base is equipped with a reversible footstand that enables the
telephone to be mounted on the wall. For instructions, refer to the M2616CT
Cordless Telephone User Guide.
This section lists the specifications required for the M2616CT (Cordless
Telephone).
The following safety procedures should be followed.
Shock hazards
The telephone is not intended for direct connection to the public switched
network or other exposed plant networks, because the exposed pins on the
handset cradle (where the handset sits) creates a possible outlet for harmful
voltage. The M2616CT is designed to be used with a Succession 1000M, a
Succession 1000M, or a Meridian 1 PBX. Before installing the M2616CT,
refer to M2616CT Cordless Telephone User Guide.
Use proper installation and charging procedures for the M2616CT battery
pack to reduce risk of fire or personal injury.
Discard the battery if the battery is cracked or damaged. A damaged battery
can leak electrolytes that are toxic if swallowed, are corrosive, and can cause
damage to the eyes and skin.
October 2003
Advertisement
Table of Contents
